Honeywell FIre-LITe ALArms MS-9600LS Manual page 123

Master Programming Level
ANN-I/O Options
Pressing 2 for Module Options while viewing ANN-BUS Address Screen when the ANN-I/O
option is selected will display the following screen:
The first screen indicates that the ANN-I/O at the selected ANN-BUS address is programmed to
annunciate SLC Loop #1 addressable modules with addresses 1 through 30. The programming can
be changed using ANN-I/O Address Screens 2 and 3.
Pressing 1 while viewing ANN-I/O Address Screen #2 will program the annunciator module to
annunciate either Point (addressable device address) information or Zone information.
Pressing 1 while viewing ANN-I/O Address Screen #3 will select the Point or Zone range to be
annunciated (refer to the tables in "ANN-I/O Zone Option" on page 123 and "ANN-I/O Point
Option" on page 125).
Pressing 2 while viewing ANN-I/O Address Screen #3 will select either addressable detectors or
addressable modules to be annunciated.
Pressing 3 while viewing ANN-I/O Address Screen #3 will select the SLC loop with the address-
able devices to be annunciated.
ANN-I/O Zone Option
If Zone is selected as the module option, the first ten LEDs on the first ANN-I/O module will dis-
play the system status information. The remaining 30 LEDs on the first module and 40 LEDs on
the remaining modules will display the active/alarm status of each zone in the Zone Range pro-
grammed for that particular module. The LED assignments for each ANN-I/O module will be as
follows.
Module LED
MS-9600LS Series Manual — P/N 52646:B2 2/12/2010
ANN-I/O ADDR #
SLC 1 MOD 001-030
ACTIVE LEDS ONLY
ANN-I/O Address Screen #1
ANN-I/O ADDR #
1=POINT/ZONE
ANN-I/O Address Screen #2
ANN-I/O ADDR #
1=RANGE
2=DET/MOD
3=SLC LOOP #
ANN-I/O Address Screen #3
ANN-I/O Module #1
Function
1 AC Fault
2 Fire Alarm
3 Supervisory
POINT
PT001-030
MOD
2
ANN-I/O Module #2 ANN-I/O Module #3
Function
Zone 30
Zone 31
Zone 32
Programming
Function
Zone 70
Zone 71
Zone 72
123