Shifter Handle Installation - Invacare 9700 Installation And Operating Instructions Manual

WARNING
There are two (2) silver plugs in the mounting
holes next to the actuator mounting bracket on
the boom. DO NOT remove these silver plugs
and use these holes at anytime or injury to the
patient and/or assistant may occur (FIGURE 6).
6. Align the holes of the boom assembly mounting
bracket with those of the actuator and insert the
bolt. Secure with nut.
NOTE: The bottom of the actuator assembly
will already be assembled to the mast mounting
bracket.
FIGURE 6 - ASSEMBLING THE ELECTRIC ACTUATOR TO THE BOOM
Shifter Handle Installation (FIGURE 7)
1. Remove the shifter handle from the packaging
carton.
2. Press down on the release button on the shifter
handle mounting tube and insert the shifter
handle over the release button until the shifter
handle locks in place. (Button MUST be protrud-
ing from the opening in the shifter handle
(FIGURE 7).
ASSEMBLY (Cont.)
WARNING
DO NOT use for
mounting.
Mounting
Bracket
NOTE: Be sure that the bolt is completely
through the holes of the boom assembly
mounting bracket and the actuator assembly.
The boom assembly will pivot easily if the
mounting hardware is aligned properly when the
boom assembly is secured to the mast.
CAUTION
DO NOT overtighten the nut and bolt and bend
the mounting bracket.
Shifter Handle
Release Button
FIGURE 7 - SHIFTER HANDLE INSTALLATION
11
ASSEMBLY
A
S
S
E
M
B
L
Y
Plastic Bushing
Actuator
Assembly