Table of Contents
Advertisement
ACCESSORIES
Operating Instructions
A
1. Set the lbs./kg switch to the desired mode.
C
C
2
With the swivel bar and sling attached to the
weight module, press the OPERATE button on
E
the front panel and adjust to ZERO by rotating
S
the adjustment knob until you obtain a displayed
S
reading of 00.0.
O
NOTE: The swivel bar and sling can also be
R
weighed separately, then subtracted from the
I
total weight which includes the patient and
E
attaching hardware.
S
3. Place the patient in the sling.
4. Lift the patient to a height sufficient enough to
ensure that the patient is not in contact with the
bed, chair, etc.
5. When the patients motion has stabilized, press
the OPERATE button and the patient's weight
will be displayed.
NOTE: The weight module will automatically turn
OFF after approximately two (2) minutes to
conserve power. If the display turns OFF before
you are able to record the patients weight,
simply press the OPERATE button once again.
6. Carefully lower the patient after reading.
HOLD FUNCTION. With the HOLD switch in the
HOLD ON position, the display reading will FREEZE
after approximately one (1) minute (lbs./kg will flash)
then automatically turn off at the end of the two (2)
minute timing cycle.
ACCESSORIES
Battery Replacement
The weight module is powered by a nine (9) volt
battery. This should provide approximately 3000
readings before needing replacement.
When battery replacement is needed, a B will
appear on the display.
Simply remove the two (2) screws on the sides of
the module and slide the housing upward to access
the battery.
Calibration and maintenance should be
performed by trained factory personnel ONLY.
The load cell transducer contains no user
serviceable components. In the event of
unauthorized tampering, warranties shall
become null and void.
38
CAUTION
Advertisement
Table of Contents
