SECTION 2— INSTALLATION
Introduction
Use only Invacare parts in the assembly of this patient lift. The base legs, mast, and
boom assembly and the swivel bar are manufactured to specifications that assure
correct alignment of all parts for safe functional operation.
Unpacking the Patient Lift
NOTE: For this procedure, refer to
FIGURE 2.1
1. Unpack the components from the
shipping carton.
NOTE: DO NOT remove the plastic wrap that
secures the boom to the mast.
Assembling the Mast to the Base
The mast may be removed from the base for storage or transporting. Each time the
mast is removed and returned to the base, the mast MUST be properly secured to
the base assembly.
NOTE: For this procedure, refer to FIGURE 2.2 on page 18.
1. If locking‐type casters are on the patient lift, lock them.
2. Remove the shoulder bolt, nut and washer, that secures the mast in the U‐shape cut‐
out of the base.
3. Position the mast in an upright position and place the mast into the U‐shaped cut‐out
of the base.
4. Insert shoulder bolt with washers through the base and mast.
5. Secure with nut.
Part No. 1145810
WARNING
FIGURE 2.1 Unpacking the Patient Lift
WARNING
17
INSTALLATION
DO NOT
remove plastic
wrap at this time
Electric Portable Patient Lift