Table of Contents
Advertisement
CONVERSION FROM A MANUAL TO AN ELECTRIC LIFT
CONVERSION FROM A MANUAL TO AN ELECTRIC LIFT
DISASSEMBLY / ASSEMBLY
Removing the Manual / Hydraulic Pump
C
Assembly (FIGURE 1)
O
N
1. Raise the lift so the boom is resting on your left
shoulder.
V
E
2. Remove the covers, bolt, nut and plastic bush-
R
ing from the hydraulic pump mounting bracket
S
on the boom assembly.
I
3. Lower the boom and pump assemblies until they
O
rest on the floor.
N
4. Remove the covers, bolt, nut, washers and
spacer from the mounting bracket on the mast
assembly.
Mast
FIGURE 1 - REMOVING THE MANUAL /
HYDRAULIC PUMP ASSEMBLY
Assembly of the Electric Actuator (FIGURE 2)
1. With the boom resting on the ground, attach the
bottom part of the actuator assembly to the mast
mounting bracket using bolt, washers, spacer,
nut and covers.
2. Lift-up on the boom and place it on your left
shoulder.
3. Let the actuator rest on the right-side of your
chest and rotate the shaft extension of the
actuator assembly until it lines-up with the
mounting bracket holes in the boom assembly.
4. Place the plastic bushing over the shaft
extension of the electric actuator.
There are two (2) silver plugs in the mounting
holes next to the electric actuator mounting
bracket on the boom. DO NOT remove these
silver plugs and use these holes at anytime or
injury to the patient and/or assistant may
occur (FIGURE 2).
5. Align the holes of the boom assembly mounting
bracket with those of the electric actuator and
insert the bolt. Secure with nut.
NOTE: Be sure that the bolt is completely
through the holes of the boom assembly
mounting bracket and the actuator assembly.
The boom assembly will pivot easily if the
mounting hardware is aligned properly when the
boom assembly is secured to the mast.
Boom
DO NOT overtighten the nut and bolt and bend
the mounting bracket.
Plastic
Bushing
WARNING
DO NOT use for
mounting.
Mast
FIGURE 2 - ASSEMBLY OF THE ELECTRIC
12
WARNING
CAUTION
Boom
Plastic
Bushing
ACTUATOR
Advertisement
Table of Contents
