Synchronization And Data Format; Signal Levels - tecan GENios Operating Manual

6.4 Synchronization and Data Format

6.5 Signal Levels

June 2002 Operating Manual for GENios, GENios FL, and GENios Plus No: I 112 904 Rev No: 1.1
For the instrument to communicate with the computer correctly, the instrument
and the computer must be set for the same communication parameters.
Check that following parameters are set correctly on the computer:
1 Start-stop synchronous system
2 Start bit length
3 Stop bit length
4 Data format
5 Parity bit
6 Baud Rate
The table below lists the voltage levels and their definitions.
VOLTAGE LEVEL
+3 to +12
-3 to -12
+3 to -3
asynchron
1
1
8 databits
none
9600
DATA SIGNALS
SPACE (Logic 0)
MARK (Logic 1)
UNDEFINED RANGE
6. Interface
CONTROL SIGNALS
ON
OFF
UNDEFINED RANGE
6-3