Before You Begin - Cisco UBR10012 Quick Start Manual

Installing the Chassis

Before You Begin

•
•
Removing the Modules from the Chassis
To remove the modules from the chassis:
Remove the front cover by pulling the cover towards you and carefully set it aside.
Step 1
Step 2 Loosen the captive screws on each of the modules to remove them from the chassis.
As the fan assembly module is heavy, ensure that it is properly supported so that it does not suddenly
Caution
swing down as the module clears the router.
Caution As some of the cards weigh as much as 16 lbs (7.3 kg), ensure that they are properly supported while
removing them from the chassis.
Cisco uBR10012 Series Universal Broadband Router–Quick Start Guide
24
Make sure that you have an antistatic surface available for the components that you are removing
from the chassis.
Make sure that you are wearing antistatic protection such as a wrist strap or heel strap and are
properly grounded.
• Fan assembly module—Pull the fan assembly halfway out of the module using the handle, then
use both hands to pull the module out of the router. You do not need to remove the fan assembly
cable. The fan assembly pulls away from the cable as the module is removed from the router.
AC or DC power entry modules—Using the two handles on the faceplate, pull the PEM modules
•
straight out from the chassis.
• PRE modules—Pivot both the ejector levers away from each other to disengage the PRE
modules from the backplane and slide the PRE module out of the slot and place it on an
antistatic surface.
Interface line cards and uplink cards—Pivot both the ejector levers away from each other to
•
disengage the line cards from the backplane. Grasp the faceplate with one hand and use your
other hand to support the card as you pull it out of the chassis. Place the card on an antistatic
surface with the component side up.
HHGE line cards—Pivot both the ejector levers away from each other to disengage the line card
•
from the backplane and slide the line card out of the slot splitter and place it on an antistatic
surface or in an antistatic bag.
OL-24972-01