Cisco UBR10012 Quick Start Manual page 49

Equipment
•
•
The color of the wire connected to pin 1 (left-most) on the connector at one end of the cable, should be
Tip
the same color as the wire connected to the left-most pin on the connector at the other end of the cable.
The same rule applies to pin 2 through pin 8 on each connector.
Figure 26
Pin 1
10BASE-T Ethernet Network
To connect the PRE to a 10BASE-T Ethernet LAN:
Connect one end of the Ethernet cable to the RJ-45 port on the primary PRE labeled Ethernet.
Step 1
Connect the other end of the cable to any unoccupied port on the Ethernet hub.
Step 2
OL-24972-01
An Ethernet hub (such as a Cisco Micro Hub)
An Ethernet cable that meets the following specifications:
RJ-45 (male) to RJ-45 (male) straight-through cable (see
–
100-ohm category 3, 4, or 5, no longer than 328 feet (100 meters)
–
Straight-Through Cable
Pin 1
How to identify a
straightthrough cable
C IS C O
10 00 0
Ethernet port
Cisco uBR10012 Series Universal Broadband Router–Quick Start Guide
Connecting Cables
Figure 26)
49