Cisco UBR10012 Quick Start Manual page 61

Tip Interfaces that are not okay (No) have an invalid configuration or are not configured.
To set up an interface on the Cisco uBR10012 router:
Enter the interface for the Fast Ethernet interface to achieve network connectivity.
Step 1
Enter interface name used to connect to the management network from the above interface
summary: FastEthernet0/0/0
Step 2 Accept the default value for the type of connector. RJ-45 is the only connector that can be used on the
Cisco uBR10012 router Ethernet port.
Configuring interface FastEthernet0/0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Configure both the Cisco uBR10012 router and the remote device to use the same mode.
Step 3
Operate in full-duplex mode? [no]: no
Enter the IP address to achieve network connectivity.
Step 4
Configure IP on this interface? [yes]: yes
Specify the IP address.
Step 5
IP address for this interface: 172.27.48.209
Enter the subnet mask for the IP address.
Step 6
Subnet mask for this interface [255.255.0.0] : 255.255.0.0
The system displays the information you entered as well as several default commands, such as the no
shutdown command. For example:
The following configuration command script was created:
hostname c10012
enable secret 5 $$1$uror$EFU0hKOBQXhk975qKFZlL0
enable password <xxx>
line vty 0 4
password <xxx>
no snmp-server
!
no ip routing
!
interface FastEthernet0/0/0
no shutdown
media-type 100BaseX
half-duplex
ip address 172.27.48.209 255.255.0.0
!
end
Step 7 Exit the setup script without saving, start the setup script, or save the configuration file:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]:
OL-24972-01
Cisco uBR10012 Series Universal Broadband Router–Quick Start Guide
Configuring the Cisco uBR10012 Router at Startup
61