Cisco UBR10012 Quick Start Manual page 17

Five LEDs (V1 POWER, V2 POWER, POWER, MISWIRE, and FAULT) indicate the status of the DC
PEM module. In addition, there is a PRODUCT ID LED/switch on the front panel of the DC PEM
module.
Table 5
Table 5
Ordered Equipment
DC PEM module (Spare)
DC PEM module and Cisco uBR10012 chassis running unsupported
Cisco IOS Release
DC PEM module and Cisco uBR10012 chassis running supported
Cisco IOS Release
1. For information on Cisco IOS Releases that support the PRODUCT ID LED/switch feature, see the
Release Notes for Cisco IOS Release
When you press the PRODUCT ID LED/switch it illuminates (green) and the Cisco IOS software
identifies the PEM module as UBR10-PWR-DC-PLUS only if you are running a supported Cisco IOS
release on the chassis. Otherwise, the software reports the default UBR10-PWR-DC product part number
and the show environment command randomly displays the PEM type as AC instead of DC.
Use a small object, such as a paper clip, to press the PRODUCT ID LED/switch inside the cavity on the
Tip
front panel of the DC PEM module.
If you are installing the DC PEM module (spare) in an existing Cisco uBR10012 router chassis, ensure
Note
that the Cisco IOS Release running on the chassis supports the PRODUCT ID LED/switch feature before
installing the module.
Even if you are using a supported Cisco IOS release, the software may not identify the PEM module as
Note
UBR10-PWR-DC-PLUS. If this occurs, ensure that the PRODUCT ID LED/switch is illuminated and
then either reload the software, or physically remove the PEM module for at least 1 minute and then
reinsert it.
OL-24972-01
lists the default activation status of the PRODUCT ID LED/switch when it is shipped.
PRODUCT ID LED/Switch Default Activation Status
1
12.2(33)SCE.
Cisco uBR10012 Series Universal Broadband Router–Quick Start Guide
Overview
PRODUCT ID LED/Switch
Status
Activated
Not activated
Activated
Cisco uBR10012 Router
17