Cisco UBR10012 Quick Start Manual page 36

Installing the Chassis
Secure the dual-hole lugs to the input studs on the DC terminal blocks by reinstalling the nuts.
Step 6
Secure the nuts using a 10 mm hex socket driver with an installation torque of 50-in lbs.
Note
Caution You must attach both pairs of DC-input cables to the DC terminal blocks on each PEM for proper
functioning of the PEMs.
Repeat
Step 7
Route the four pairs of DC-input cables from the DC power terminal blocks on both the PEMs down
Step 8
through the front of the chassis through the three retaining power cord clips. (See
Note Ensure that you lift the handles and route the cables underneath the handles and through the power cord
clips of the PEM modules as shown in
chassis.
Cisco uBR10012 Series Universal Broadband Router–Quick Start Guide
36
Step 3 to Step 6 to connect the second facility DC power source to the second PEM module.
Figure 17 so that the front cover fits on the Cisco uBR10012
Figure 17.)
OL-24972-01