Cisco UBR10012 Quick Start Manual page 5

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
For translations of the warnings used in this document, see the Cisco Regulatory Compliance and Safety
Information document that comes with this chassis. Reference the translations by statement number (ex:
Statement 1030).
Cisco uBR10012 Universal Broadband Router Components
The Cisco uBR10012 router chassis is designed for front and rear access. The two AC or DC power entry
modules (PEMs), two Performance Routing Engine (PRE) modules, an LCD panel, and the fan assembly
module are accessed from the front of the chassis. The eight slots for cable interface line cards, four full
slots for network uplink line cards, and two slots for the Timing, Communication, and Control Plus
(TCC+) and the DOCSIS Timing, Communication, and Control (DTCC) cards are accessed from the rear
of the chassis. (See
Figure 2
Note
(UBR10-PWR-DC=) modules.
If the only available power supply source is 100-120 VAC, you can use the auxiliary AC-input power
Note
shelf. The AC-input power shelf converts AC to DC power for the Cisco uBR10012 router. If you are
using the optional 2400 W AC-input power shelf, refer to
Guide.
OL-24972-01
Figure 2.)
is a sample representation of the Cisco uBR10012 chassis with the DC PEM
Cisco uBR10012 Series Universal Broadband Router–Quick Start Guide
2400W AC-Input Power Shelf Installation
Overview
5