Cisco UBR10012 Quick Start Manual page 46

Installing the Chassis
Installing the HHGE Line Cards
Always install the HHGE line cards in a slot splitter. Slot splitters must be installed in Slot 3 or Slot 4
Caution
of the chassis. If you have a blank slot, always install a blank slot cover. Use half-height slot covers when
you have a single open HHGE slot. Use full-height slot covers in all other situations.
To install the HHGE line cards in the Cisco uBR10012 router:
Grasp the faceplate of the line card with one hand and place your other hand under the card carrier (to
Step 1
support the weight of the card). Position the card in front of the slot splitter.
Carefully align the upper and lower edges of the line card with the upper and lower guides in the slot
Step 2
splitter, and slide the line card about half-way into the splitter.
Be sure the ejectors are in the open position and continue to push the line card into the splitter until you
Step 3
can feel it begin to seat in the backplane connectors.
Verify that the captive screws are properly aligned with the captive screw holes in the splitter. If the
Step 4
captive screws are not properly aligned, the card will not seat properly in the backplane.
To tighten the captive screws on the line cards, the installation torque used should be 8 in-lbs.
Note
Step 5 Pivot both ejector levers toward each other (until they are parallel to the faceplate) to firmly seat the card
in the backplane.
The HHGE line card cycles through its power-on self-test (POST). The FAIL LED illuminates during
portions of the POST, but remains off after POST on a working line card. If the FAIL LED remains
illuminated, go to the
Cisco uBR10012 Series Universal Broadband Router–Quick Start Guide
46
"Troubleshooting" section on page 63.
OL-24972-01