Cisco UBR10012 Quick Start Manual page 44

Installing the Chassis
Do not remove the required EMI gaskets from the UBR10012-FAN-PLUS= fan assembly module.
Caution
Note The EMI gaskets on the Cisco uBR10012 router chassis are used with the UBR10-FAN-ASSY= fan
assembly module. For information on installing EMI gaskets, see
Absorber Material on the Cisco uBR10012 Universal Broadband
To install the fan assembly module from the Cisco uBR10012 router:
Step 1 Using both your hands, pick up the fan assembly module.
Align the module with the rails in the chassis. (See
Step 2
Push the fan module back firmly into the chassis, making sure that the module securely connects to the
Step 3
backplane.
Step 4 Tighten the captive screws on each side of the fan assembly module.
To tighten the captive screws on the fan assembly modules, the installation torque used should be 8
Note
in-lbs.
The total service window for removal and replacement of the fan tray is 3 minutes before possible system
Caution
shutdown. Ensure that you complete the replacement procedure within this time limit.
Figure 23
Cisco uBR10012 Series Universal Broadband Router–Quick Start Guide
44
Installing the Fan Assembly
Installing EMI Gaskets and RF
Router.
Figure 23.)
OL-24972-01