Cisco UBR10012 Quick Start Manual page 56

Powering On the Cisco uBR10012 Router
After powering on the AC power source, verify the LEDs on the AC PEMs:
Step 3
•
•
Turn the power switch on the AC PEMs to the ON position.
Step 4
Figure 30
Figure 31
Figure 30
ALAR MS
ALAR MS
Figure 31
CIS CO
100 00
Cisco uBR10012 Series Universal Broadband Router–Quick Start Guide
56
UBR10-PWR-AC= module—The FAULT LED on each PEM illuminates (yellow), indicating
that the PEM is receiving power from the AC power source but is not yet supplying power to
the chassis (because its power switch is off).
UBR10-PWR-AC-PLUS= module—The V1 POWER and V2 POWER LEDs on each PEM
should illuminate (green). These LEDs only indicate that an input voltage is present on the
PEMs and not that the PEM is powered on. In addition, the FAULT LED on each PEM
illuminates (yellow).
is a sample representation of the AC power switch on the UBR10-PWR-AC= module.
is a sample representation of the AC power switch on the UBR10-PWR-AC-PLUS= module.
AC Power Switch UBR-10-PWR-AC=
AC
SWIT CH
AC
SWIT CH
ACIN PUT
200-2 40V
13A 50/60
Hz
A C IN P U
ACIN PUT
200-2 40V
13A 50/60
Hz
2 0 0 -2 4 0
1 3 A 5 0 /6
AC Power Switch UBR10-PWR-AC-PLUS=
EN AB LE
20 0- 24 0V
~, 13 A, 50
/60 Hz
EN AB LE
V1 PO W
ER
CIS CO
100 00
V2 PO W
ER
PO W ER V1 PO W
ER
V2 PO W
ER
FA UL T
PO W ER
FA UL T
A C
S W IT C H
T
V
0 H z
E N A B L E
20 0- 24 0V
~, 13 A, 50
/60 Hz
2 0 0 - 2 4 0
V ~
OL-24972-01