Connecting Cables To Transceivers - Aruba 8360 Series Installation And Getting Started Manual

Press the small tab on the plug and pull the plug out of the port.

Connecting Cables to Transceivers

If you have any transceivers installed in the switch, the type of network connections you will need to use
depends on the type of transceivers installed. See Cabling and Technology Information.
For transceiver ports, and in general for all the switch ports, a network cable from an active network device is
connected to the port. If the port LED does not come on when the network cable is connected to the port,
see Diagnosing with the LEDs in the Troubleshooting chapter.
Ports are disabled by default.
46
Aruba 8360 Switch Series | Installation and Getting Started Guide