Two-Post Rack Mount Option - Aruba 8360 Series Installation And Getting Started Manual

Rear position (switch extends 410 millimeters behind the rack post)
n
Aruba X414 1U Universal 4-Post RM Kit (JL9583B)
4-Post rack mountable with 4-Post rack mount kit in Port-to-Power or Power-to-Port configurations.

Two-post Rack Mount Option

The switch is designed to be mounted in any EIA-standard 19-inch telco rack or communication equipment
cabinet using the Aruba X412 1U Universal 2-Post Rack Mount Kit.
For safe operation, please review the mounting precautions in
mounting a switch.
The 12-24 screws supplied with the two-post rack mount kit are the correct threading for standard EIA/TIA open
19- inch racks. If installing the switch in an equipment cabinet such as a server cabinet, use the clips and screws
that came with the cabinet in place of the 12-24 screws that are supplied with the two-post rack mount kit.
Complete step 1, and plan which four holes you will be using in the cabinet and install all four clips. Then proceed
to step 2.
1. Use a T20 drive screwdriver and attach the mounting brackets to the switch with the included 6-mm
M4 screws.
The brackets can be attached in three different positions to achieve the following:
Front position (front of switch, port side, is flush with front of rack).
n
Center-of-Gravity position (switch is centered with weight evenly distributed).
n
Rear position (rear of switch, power side, aligns with front of rack - some components protrude,
n
not flush).
Aruba 8360 Switch Series | Installation and Getting Started Guide
Installation Precautions and Guidelines, before
38