Table of Contents
Advertisement
Be sure special washers are installed on roller plate
bolts at 1.
NOTE: If the clearance is excessive, more than
3.175 mm (0.125
), at all four cam track rollers, the
"
cam track may have moved out from the reel. Move
the cam track in before reshimming the roller plates.
SPECIAL WASHERS
To move the cam track in:
1. Loosen the set screw in the lock collar inside the
reel support.
2. Loosen the lock collar with a punch and hammer.
The lock collar must be turned opposite the
direction the reel rotates.
3. Move the support and cam track in on the reel
shaft and header to reduce roller clearance.
SECTION 4 - MAINTENANCE
ROLLER PLATE SHIMS
(DOTTED LINES)
CAM TRACK
.010" TO .125"
(.25 TO 3.175 MM)
CLEARANCE
ROLLER PLATE
ROLLER
SPECIAL WASHERS
5/8" FLAT WASHERS
1
1004732
REEL TUBE
(E)
5
1
THICK SPACER (2)
CAM
CAST BEARING
BEARING AND
HOUSING
LOCK COLLAR
REEL SHAFT
BUSHING
GREASE
FITTING
LEFT REEL
SUPPORT
4. Tighten the bearing lock collar by turning it in the
direction the reel rotates. The collar must be tight.
5. Tighten the lock collar set screw.
6. Tighten the two bolts holding the reel support to
the header.
7. Loosen the two bolts which hold the reel supports
to the top of the header.
4-40
BEARING AND
HOUSING (2)
4
BEARING (2)
2
SNAP RING (2)
UNIVERSAL
C
DIRECTION OF
3
ROTATION
SPIDER LEG
FRONT
56
57
Hide quick links:
Advertisement
Table of Contents
