Table of Contents
Advertisement
If the bolt slots are not long enough, remove bolt, 1.
Move hub, 2, to the next flat on the hex shaft, 3.
Retighten clamp bolt, 1. Readjust roll timing.
When timing is correct, tighten all hardware securely.
IMPORTANT: Check roll timing at each end of the
rolls. If the rolls are timed correctly at one side, but not
at the other, rotate the rolls and recheck the roll
timing. If one end is still not timed correctly, move the
top roll endways at the roll bearings and readjust roll
timing.
To adjust roll gap add or remove shims at the roll ends
as shown. Adjust to a minimum of 0.38mm (0.015").
SECTION 4 - MAINTENANCE
10004733
NOTE: The rolls must not touch each other or
damage will occur.
4-44
1
3
2
63
64
Hide quick links:
Advertisement
Table of Contents
