Table of Contents
Advertisement
1000 RPM PTO UNITS
IMPORTANT: Coat the tractor PTO splines and
splines in the pump, 1, all the way onto the PTO shaft,
until the slide collar is fully engaged.
IMPORTANT: The torque arm, 2, must be against the
right side of the drawbar to keep the pump from
rotating. Move the torque arm up on the pump plate
to prevent dragging in the windrows. Always loop the
chain around the drawbar and secure the chain in the
keyhole slot in the pump plate.
The 1000 RPM direct drive pump attaches to the
tractor by pulling back on the ring at the end of the
PTO pump coupler, 1. The ring will snap into place,
remaining retracted.
Push the pump onto the shaft. When the pump is on the
shaft, the retaining ring will return to the forward position.
Continue to push the pump onto the PTO shaft until it
is fully seated. The pump should not slide off the PTO
shaft without pulling back on the retaining ring.
SECTION 1 - GENERAL INFORMATION
1-8
1
19984845
19983052
19983053
2
16
1
17
18
Hide quick links:
Advertisement
Table of Contents
