Table of Contents
Advertisement
4
GUARDS USED
Qty.
Center
1
Left & right end
2
Standard
22
Guard Installation
Shim the guards, 1, and hold down clips, 2, to allow the
knives to overlap properly. The left knife should be 3 mm
(0.120") lower than the right knife.
Install a 3 mm (0.120") shim, 3, between the guard and
cutter bar at all guards (standard or stub guards) to the
left of the center guard. DO NOT place a shim between
the center guard and cutter bar. DO NOT place shims
between the cutter bar and the guards to the right of the
center.
SECTION 4 - MAINTENANCE
2
4
4
1
When the machine is equipped with standard guards
install a 3 mm (0.120") shim, 4, under the center
hold-down clip and all hold-down clips to the right of the
center clip.
When the machine is equipped with stub guards, the
center hold-down clip and all hold-down clips to the right
of the center clip will require an additional 3 mm (0.120")
shim compared to the left clips.
4-23
3
32
Hide quick links:
Advertisement
Table of Contents
