Installing The Rear Wheel - Husqvarna FS 450 2018 Repair Manual

14.8.2

Installing the rear wheel

Warning
Danger of accidents
-
Always keep the brake discs free of oil and grease.
-
Clean the brake discs with brake cleaner when necessary.
Oil or grease on the brake discs reduces the braking effect.
Main work
-
Check the wheel bearing for damage and wear.
If the wheel bearing is damaged or worn:
-
Change the rear wheel bearing.
-
Clean and grease shaft seal rings
surfaces
I
Long-life grease
-
Insert the spacers.
-
Clean and grease the wheel spindle.
I
Long-life grease
-
Position the rear wheel and insert wheel spindle
✓ The brake linings are correctly positioned.
Mount the chain.
-
Position chain adjuster
it yet.
-
Make sure that chain adjusters
adjusting screws
-
Check the chain tension.
-
Tighten nut
Guideline
Nut, rear wheel spin-
die
• Info
I
The wide adjustment range of the chain adjusters
(32 mm (1 .26 in)) enables different secondary ratios
with the same chain length.
Chain adjusters
-
Operate the foot brake lever repeatedly until the brake lin­
ings are in contact with the brake disc and there is a pressure
point.
Finishing work
-
Remove the motorcycle from the lift stand.
O
f)
of the spacers.
(IOJ p. 302)
(IOJ p. 302)
4D.
Mount nut
8
are fitted correctly on
0.
(IOJ p. 126)
C,.
M25x1 .5
8
can be turned by 180
WHEELS 14
(IOJ p. 133)
and contact
8.
C,,
but do not tighten
80 Nm (59 lbf ft)
°
.
(IOJ p. 12)
...
125