Table of Contents
Advertisement
Note: All Error messages are followed by the phrase:
These messages occur when attempting to go to the run-
ning mode without entering necessary information or
entering a value that is not allowed.
Messages
Temp hi-lo lim err:
been entered or a low limit is higher than a high limit.
Press hi-lo lim err:
entered or a low limit is higher than a high limit.
Flow hi-lo lim err:
tered or a low limit is higher than a high limit.
Need more flow info:
not been entered.
Z factor error:
number greater than zero.
Scale factor error:
number greater than zero.
No value stored yet:
initialization. Enter a value.
Bad lock code:
lockout code, use any other number than 00000 to lock out computer.
Syntax error:
Refer to Section 3.12 for proper format.
Bad Time value:
proper format.
Bad Date value:
proper format.
Bad ID value:
proper format.
Appendix iii
Programming Error Messages
"Push ENT to continue".
Temperature input parameters have not
Pressure input parameters have not been
Flow input parameters have not been en-
All of the Flow input parameters have
Z factor has been set to zero, change to any
K factor has been set to zero, change to any
The unit still has the null value in it from
Attempt has been made to enter 00000 as the
Time or date was not entered in proper format.
Invalid time entered. Refer to Section 3.12 for
Invalid date entered. Refer to Section 3.12 for
Invalid ID entered.
Refer to Section 3.13 for
Advertisement
Chapters
Table of Contents
