Table of Contents
Advertisement
10. Uncompensated
Flow
11. Raw Flow
(Channel 3)
12. Raw Temperature Raw temperature input
(Channel 1 or 2)
13. Raw Pressure
(Channel 2)
14. Raw RTD Input
(Channel 1 or 2)
15. RTD Ohms
(Channel 1 or 2)
16. Analog Output
17. Specific Volume
18. Specific Enthalpy Current Specific Enthalpy
19. Flow Frequency
The operator can designate the items of this list that will
be displayed, and in which order they will be displayed.
Each item will be displayed about two seconds. Addition-
ally, each point can be displayed more than once in the
scan list. If you find that a parameter is not being dis-
played long enough, select it twice in a row.
Note: The parameters available for display selection is
dependent upon selections made in the Setup menu (Set
Computations, Set Hardware and Set Variables).
system automatically determines the display based on
programmed parameters.
Use the following menu to set up the list of items that you
would like to be displayed while the machine is running:
Volumetric flow rate
per minute
Raw flow input
(Value of Full Scale)
(Value of Full Scale)
Raw pressure input
(Value of Full Scale)
Raw RTD input
(Value in mA)
Resistance of RTD device
Value in mA
Current Specific Volume
(from Steam Tables)
(from Steam Tables)
Raw pulse frequency in
3-33
The
Advertisement
Chapters
Table of Contents
