Flowmetrics 922-MFC Installation And Operating Instructions Manual page 25

Refer to Appendix i for a complete listing of parameters
used in this section and the units required for various
flow equations and units of measure.
To get to the Variables menu . . .
Display shows
Run?
Set Computations?
Set Variables?
Pressure Input?
In the same manner that you set the Computations and
the Hardware you will set the variables for the instru-
ment.
Use the numeric keypad to input the desired variables for
the instrument in the Variable menu. The D key sets
the decimal point when entering a numerical value.
The example below shows how to enter the value of
256.58 PSIG.
At input = minimum
Lo press? 2
The D key inserts a decimal point.
The ENT key enters the data into memory.
5 6 D
Press
A
A
ENT
A, B, C, or ENT
5 8 ENT
3-10
until . . .