Checking The Alarm - Flowmetrics 922-MFC Installation And Operating Instructions Manual

3.10 Checking the Alarm

If the alarm should go off
anytime during the Stand
by or Running modes of the
Flow Computer, you can
easily check which point has
most recently gone into
alarm by following these
menu steps:
DISPLAY
Run?
Set Computations?
Continue Pressing A until
Clear Totalizer?
Check Alarm?
(Alarm Condition Shown)
Press ENT to quiet.
This procedure will have to
be completed for each alarm
condition. Until No Alarm
Condition is shown. In
which case the menu will
advance to . . .
Lock / Unlock?
Check Alarm:
PRESS
A
A
A
ENT
Used to view the most recent alarm condition.
See appendix iv for possible alarm conditions.
On the RUNNING side of
the menu, you have another
opportunity to check an
alarm condition:
DISPLAY
Running...
Show Data?
Running...
Go To Standby?
Continue Pressing A until
Running...
Examine Variables?
Running...
Alarm Check?
(Alarm Condition Shown)
Press ENT to quiet.
This procedure will have to
be completed for each alarm
condition. Until No Alarm
Condition is shown. In
which case the menu will
return to . . .
Running...
Show Data?
3-23
PRESS
A
A
A
ENT