Flowmetrics 922-MFC Installation And Operating Instructions Manual page 18

Standby Mode
Set Computations?
Engineering Units?
Set Hardware?
Set Variables
Clear Totalizer?
Check Alarm?
Lock / Unlock?
Real time clock?
Serial interface?
Press ENT to enter the selected menu subroutine.
Press C (cancel) at any time to return to the "Run?" or "Go
to standby?" prompt.
Run? allows you to cross over from Setup to Run.
Go to standby? allows you to cross over from Run to
Setup.
When in Standby mode, you can Setup and change the
operating parameters of the instrument.
When in Run mode, you can Examine the operating pa-
rameters of the instrument.
In either mode you can check the alarm, clear the total-
izer, or access the lock.
Top Level Menu Items
Run?
ENT
A B
A B
A B
A B
A B
A B
A B
A B
A B
Figure 3-1
Operation Mode
Show Data?
A
Go to standby?
ENT
A
Setup data display?
A
Setup print list?
A
Print system setup?
A
Clear Totalizer?
A
Examine Hardware?
A
Examine Comps?
A
Examine Variables?
A
Check Alarm?
A
Lock / Unlock?
3-3
B
B
B
B
B
B
B
B
B
B