Setting Up The Data Display - Flowmetrics 922-MFC Installation And Operating Instructions Manual

3.15 Show Data?
This menu item will start the data list scrolling on the
front of the LCD display.
DISPLAY
Run?
Show Data?
Set up list first!
Push ENT to continue
If you get the following, you have not set the display list of
data, and should refer to Section 3.16.

3.16 Setting up the Data Display

During normal operation, the instrument may be set up to
display the important operating data such as flow rate,
temperature, or pressure.
scanned and displayed on the front panel of the instru-
ment:
1. Time & Date
2. Flow Rate
3. Mass Flow
4. Heat Flow
5. Totalizer (Flow) Compensated accumulated flow
6. Totalizer (Mass) Compensated accumulated mass flow
7. Totalizer (Heat) Compensated accumulated heat flow
8. Temperature
9. Pressure
Continued on next page.
The following data can be
Current Time and Date
In rate units per minute or hour
In mass flow units per minute or hour
In heat flow units per minute or hour
Scaled in engineering units
Scaled in engineering units
3-32
PRESS
ENT
ENT