Table of Contents
Advertisement
1. Record the user's data of 5 User Setting Programs.
2. Display Speed (RPM), TIME and WATT., CAL and DIST, at the same time.
3. The computer will turn off automatically if there is no operation, speed signal and pulse signal over
4 minutes. Meanwhile, it will store your current exercise data and urn the loading resistance to the
minimum. Once you press any button or in motion, the computer will turn on automatically.
4. There are 10 columns of loading bars , and 8 bars in each column. Each column represents 1 minutes
workout (without the change of TIME value), and each bar represent 2 levels of loading.
BUTTONS
1. ENTER:
• In "stop" mode, press ENTER button to enter into program selection and setting value which flash in
related window.
A: When you choose the program, press Enter to confirm the one you like.
B: When in setting, press ENTER to confirm the value that you would like to preset.
• During the start mode, press ENTER to choose display the speed or RPM, or switch automatically.
2. START/STOP:
• Press START/STOP button to start or stop the programs.
• During any mode, hold down this button for 2 seconds to totally reset the computer.
3. UP:
• In stop mode and the dot matrix character flash, press this button to select the program up. If the
related window value flash, press this button to increase the value.
• During the start mode, press this button to increase the training resistance.
OPERATION MANUAL |
17
Advertisement
Table of Contents
