Advertisement
Operation
Residual heat during pan detection
If any residual heat indication is recognized by the system, "H" is displayed on the related zone of the left
LCD TS.
If a pot is taken off from a zone of the FLEXI the single zone will blink on the left LCD TS for the first 15 sec.
"H" won't be displayed
After 15 sec the linked zone will show a zebra texture with "H" on it. It means that the zone is linked to the
running one of the FLEXI but it still has some residual heat on it (picture above).
"H" will disappear as soon as the zone will be cold again (picture below).
The zone will remain with zebra texture because still linked to the running one. The hob will not go in OFF
till the running zone will be switched OFF.
The same behavior is applied to each combination of zones when a FLEXI is created
If the whole zone is not covered, it blinks for 30 sec., then it turns off and displays "H"
WHIRLPOOL CORPORATION ▪ CONFIDENTIAL ▪ EMEA CS&Quality Technical Training and Serviceability Team ▪ By Nicola Padula and Nicola Bargagnati
Advertisement
