Advertisement
Operation
Pan detection
The user, while cooking, decides to take out the pot from the running zone.
MAIN ACTION FROM THE USER
If the user is cooking on one single zone and he takes out the pot the hob goes in pan detection. The left
LCD TS starts blinking for 30 sec.
It means that pot is missing and hob is in pan detection.
If within 30 seconds, the user slides or lifts up and repositions the pot to different zone, the new area shows
the pre-set power level alternate to a question mark. The display on the right shows: "press to confirm
power level".
If the user presses ok: power level is confirmed
If the user press on blinking zone: power level is confirmed.
If the user touch the slider: new power level is set.
has some residual heat you will see "H" on the zone
If the pot
After 30 sec the selected zone goes in OFF
WHIRLPOOL CORPORATION ▪ CONFIDENTIAL ▪ EMEA CS&Quality Technical Training and Serviceability Team ▪ By Nicola Padula and Nicola Bargagnati
Advertisement
