Advertisement
Operation
Set french plaque function
It is possible to associate the FRENCH PLAQUE function. With this function the surface is subdivided in 4 zones
at pre-set power levels: 1 LOW 2 MEDIUM and 1 HIGH
MAIN ACTION FROM THE USER
The user taps on the U button.
Using the right arrow goes to French Plaque function. He selects the function using the Check icon.
The surface is set at 4 pre-set cooking power level
The user adds a pot on the hob and taps "ADD A POT" icon on the right LCD TS. This performs a refresh
allowing the hob to detect where the pot has been added
Every time the user adds a pot he has to tap on "ADD A POT" icon on the right LCD TS. If the user changes the
position of the previously added pot this action is not needed
It is possible to Exit from the French Plaque function by tapping on the EXIT icon on the right LCD TS.
If the selected zones are not covered by the pot the enlighten zones in the left LCD TS will blink for 30 seconds.
•
If no action are performed, after 30s the zone switch OFF
•
If no other zone are active, after 30s the hob switch OFF
It is possible to configure the power level of each quarter of the hob
It is possible to switch off the zone by sliding on OFF cooking zone goes in OFF
WHIRLPOOL CORPORATION ▪ CONFIDENTIAL ▪ EMEA CS&Quality Technical Training and Serviceability Team ▪ By Nicola Padula and Nicola Bargagnati
Advertisement
