Advertisement
8.) Adjusting the belt steering blocks is performed by loosening the M10x25 bolt with a 16mm
wrench. Press the block so that the roller is against the back of the saw belt, the roller must not
push the sawblade forward as this affects the sawblades movement. Adjust so that the saw
blade runs smoothly adjusts if necessary, then tighten the bolts. The distance between the
band and the top and bottom of the block shall be 0.5mm.
The distance between the blade and
the block should be 0.5mm on top and
underneath
9.) Mount the brush inside the machine as the pictures, shown below.
10.) Reassemble the protective cover.
25
Table of contents
Advertisement
