Advertisement
B.) ADJUSTMENT: UP AND DOWN
If the wheel is skewed så that either the upper part (Fig 3) or the lower part (Fig4) of the
wheel is too close to the protective cover:
Fig 4
Fig 3
MEASURE
If the wheel is skewed as shown in FIG. 3, loosen the top adjuster bolt (# 7) with 19mm key
and adjust it upwards until you reach the right height. If the wheel is skewed shown in FIG. 4,
adjust the bolt downwards. It is important that the upper and lower nuts are adjusted simulta-
neously. The same number of turns should be turned on each side.
6.) Perform the previous step if fine adjustment is required when the saw belt is already
tensioned. Turn the wheels and check the distance between the wheels and the protective
cover.
7.) When the wheels are fully aligned, tighten all bolts.
24
Table of contents
Advertisement
