Advertisement
ASSEMBLY - RAIL FEET
f.) Mount the rail feet on the side of the rails. The rail has 12 holes for the assembly of rail feet
g.)Mount the connecting plate of the for the 2 section outer side of the rail, do not tighten the
bolts yet.
h.) Lift the cutting head unit onto the rail. Warning! The saw mills cutting head is very heavy, be
cautious when lifting the unit. This step is required to be done by at least 2 people.
i.) After installing the unit onto the rail, push the unit forward to check if it rolls smoothly,
adjust the feet or the position of the section if necessary before tightening all bolts. Check the
joint points of the rail, make sure that the sections are aligned with each other before tighten-
ing all bolts.
20
Table of contents
Advertisement
