How To Install Or Remove A Pillow Block - Cisco Carrier Routing System CRS-1 Installation Manual

How to Install or Remove a Pillow Block

Required Tools and Equipment
You need the following tools and part to perform this task:
•
•
•
Steps
To install a slide-assistance arm, follow these steps:
Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection
Step 1
sockets on the front (PLIM) side of the chassis or a bare metal surface on the chassis.
Place the slide-assistance arm against the card face so that the screw holes on the card align with the
Step 2
captive screws on the slide-assistance arm.
Using the screwdriver, turn the two screws (one top, one bottom) clockwise to attach the slide-assistance
Step 3
arm to the card face.
Note
What to Do Next
After performing this task, you may install or remove the card as necessary.

How to Install or Remove a Pillow Block

This section contains the following procedures:
•
•
Cisco CRS Carrier Routing System 4-Slot Line Card Chassis Installation Guide
4-14
Chapter 4
ESD-preventive wrist strap
Number 2 Phillips screwdriver
Card:
– MSC (CRS-MSC, CRS-MSC-B, or CRS-MSC-140G;
– FP (CRS-FP40 or CRS-FP-140);
– LSP (CRS-LSP);
RP card (CRS-4-RP) or PRP card (CRS-4-PRP-6G or CRS-4-PRP-12G);
–
PLIM (Refer to the product data sheets for ordering details.)
–
We recommend keeping the original Cisco packaging for future storage of the slide-assistance
arm, should it become necessary.
Installing a Pillow Block, page 4-15
Removing a Pillow Block, page 4-16
Installing and Removing SFCs, RPs, MSCs, FPs, LSPs, PLIMs, and Associated Components
OL-10971-10