Cisco Carrier Routing System CRS-1 Installation Manual page 106

How to Install or Remove an MSC, FP, or LSP
Grasp the face plate of the card with one hand and place your other hand under the card to support and
Step 7
guide it into the correct slot (see
Figure 4-21
1
2
1 Captive screw
2 Ejector lever
Orient the line card so that the status display is on top, then position the card for insertion into the card
Step 8
cage slot. Avoid touching the card circuitry or any connectors.
Note
Step 9 Grasp both card ejector levers simultaneously, then push them both outward until they are fully extended
in the open position.
Cisco CRS Carrier Routing System 4-Slot Line Card Chassis Installation Guide
4-36
Chapter 4 Installing and Removing SFCs, RPs, MSCs, FPs, LSPs, PLIMs, and Associated Components
Figure
Installing a MSC, FP , or LSP Card
3
There are alignment grooves on each slot in the card cage. When you install a card, make sure
that you align both the top and bottom edges of the card carrier in the slot grooves.
4-21).
3 Direction of installation or removal
OL-10971-10