Cisco Carrier Routing System CRS-1 Installation Manual page 134

Installing the Doors
Keeping the knob latch at a shallow angle, align the securing pin and guide pin with the upper door
Step 7
mounting bracket.
Note
Pull the knob out, then drop the securing pin into the mounting bracket (see Step 3 in
Step 8
To close the door, lift the latch button at the base of the door (see
Step 9
The door will snap closed when the door magnets (on the inside top of the door) snap into place and the
latching pin on the bottom of the door falls into the receiving holes on the striker panel (see
Repeat this procedure for the right door.
Step 10
Figure 5-5
Cisco CRS Carrier Routing System 4-Slot Line Card Chassis Installation Guide
5-6
You must align both the knob latch and the guide pin before the securing pin will drop properly.
Lifting the Latch Button to Open the Door
L I F
T A
N D
P U
L L
Chapter 5 Installing and Removing the Doors and Grille
Figure 5-5), then push the door closed.\
L IF
T A
N D
P U
L L
Figure 5-4).
Figure 5-6).
OL-10971-10