Installing A Card Slide-Assistance Arm - Cisco Carrier Routing System CRS-1 Installation Manual

Chapter 4 Installing and Removing SFCs, RPs, MSCs, FPs, LSPs, PLIMs, and Associated Components
Prerequisites
No prerequisites exist for this task.
Do not lift cards by the slide-assistance arm. Rotate cards onto their vertical axes, then lift them from
Caution
the bottom, using the slide-assistance arm only as an aid for balance.
Required Tools and Equipment
You need the following tools and part to perform this task:
•
•
Steps
To remove a slide-assistance arm, follow these steps:
Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection
Step 1
sockets on the front (PLIM) side of the chassis or a bare metal surface on the chassis.
Using the small Phillips screwdriver, turn the two captive screws (one top, one bottom) on the
Step 2
slide-assistance arm counter-clockwise to detach the arm from the card face.
Set the slide-assistance arm carefully aside. We recommend storing it in the original Cisco packaging.
Step 3
What to Do Next
After performing this task, you may install or remove the card as necessary.

Installing a Card Slide-Assistance Arm

This section describes how to install a slide-assistance arm on a line card, PLIM, or RP card. For details
about installing or removing the cards themselves, see the
LSP" section on page
the
Prerequisites
Before performing this task, be sure to remove the slide-assistance arm and its attachment screws from
the packaging, and have the appropriate card available for attachment.
Do not lift cards by the slide-assistance arm. Rotate cards onto their vertical axes, then lift them from
Caution
the bottom, using the slide-assistance arm only as an aid for balance.
OL-10971-10
ESD-preventive wrist strap
Number 3 Phillips screwdriver.
4-32, the
"How to Install or Remove a Physical Layer Interface Module" section on page
Cisco CRS Carrier Routing System 4-Slot Line Card Chassis Installation Guide
How to Remove or Install a Card Slide-Assistance Arm (Handle)
"How to Install or Remove a PCMCIA Card" section on page
"How to Install or Remove an MSC, FP, or
4-42.
4-51, and
4-13