How To Install Or Remove A Switch Fabric Card - Cisco Carrier Routing System CRS-1 Installation Manual
Carrier routing system 4-slot line card chassis
Hide thumbs
Also See for Carrier Routing System Cisco CRS-1:
- Administration manual (436 pages) ,
- Getting started manual (289 pages) ,
- Troubleshooting manual (264 pages)
Table of Contents
Advertisement
Chapter 4
Installing and Removing SFCs, RPs, MSCs, FPs, LSPs, PLIMs, and Associated Components
How to Install or Remove a Switch Fabric Card
Figure 4-12
Switch Fabric Card (QQ123-140G)
Prerequisites
Before performing this task, remove the switch fabric card (if there is already one installed) or the switch
fabric impedance carrier from the slot in which you plan on installing the switch fabric card. See the
"Removing an Impedance Carrier" section on page 4-10
and the
"Removing a Switch Fabric Card"
section on page
4-22.
Cisco CRS Carrier Routing System 4-Slot Line Card Chassis Installation Guide
4-19
OL-10971-10
Advertisement
Table of Contents
