Cisco Carrier Routing System CRS-1 Installation Manual page 105

Chapter 4 Installing and Removing SFCs, RPs, MSCs, FPs, LSPs, PLIMs, and Associated Components
Required Tools and Equipment
You need the following tools and part to perform this task:
•
•
•
•
Steps
To install a modular services card, follow these steps:
Step 1 Go to the front of the chassis. Attach the ESD-preventive wrist strap to your wrist and connect its leash
to one of the ESD connection sockets on the front side of the chassis or a bare metal surface on the
chassis.
Remove the line card from its antistatic packaging.
Step 2
Step 3 Use a medium Phillips screwdriver to remove the line card from its protective carrier.
Step 4 Remove the slide-assistance arm (handle) currently attached to the line card:
a.
b.
Visually inspect the connector pins on the card before you insert it into the chassis.
Step 5
Note
Identify the card slot in the card cage where the line card should be installed.
Step 6
a.
Note
b.
OL-10971-10
ESD-preventive strap
Small Phillips screwdriver
Medium flat-blade or Phillips screwdriver
Card:
– Modular services card (Cisco product number: CRS-MSC, CRS-MSC-B, or CRS-MSC-140G.
See the product data sheet for ordering details.)
Forwarding Processor (FP) card (Cisco product number: CRS-FP40 or CRS-FP-140. See the
–
product data sheet for ordering details.)
Label Switch Processor card: (Cisco product number: CRS-LSP. See the product data sheet for
–
ordering details.)
Using a small Phillips screwdriver, turn the two captive screws (one top, one bottom) on the
slide-assistance arm counter-clockwise to detach the arm from the card face.
Set the slide-assistance arm carefully aside. We recommend storing it in the original Cisco
packaging.
Do not attempt to install a card with bent pins, because this may damage the chassis midplane
connectors.
If there is an impedance carrier in the slot, remove it (see the
section on page 4-10.)
Remove only one impedance carrier and install one line card at a time. Be sure to verify that
each line card is fully installed and secured before installing another card.
If there is a line card already installed in the slot, remove the card (see the
or LSP" section on page 4-37).
Cisco CRS Carrier Routing System 4-Slot Line Card Chassis Installation Guide
How to Install or Remove an MSC, FP, or LSP
"Removing an Impedance Carrier"
"Removing an MSC, FP,
4-35