Cisco Carrier Routing System CRS-1 Installation Manual page 127

Chapter 4 Installing and Removing SFCs, RPs, MSCs, FPs, LSPs, PLIMs, and Associated Components
Figure 4-35
Step 5 Place the removed module on an antistatic mat, or immediately place it in a static-shielding bag if you
plan to return it to the factory.
Protect the PLIM by inserting clean SFP module cage covers into the optical module cage when there is
Step 6
no module installed.
OL-10971-10
Removing a Bale-Clasp SFP Module
2
2
Cisco CRS Carrier Routing System 4-Slot Line Card Chassis Installation Guide
How to Install or Remove a Small Form-Factor Pluggable (SFP) Module
3
4 O C
4 8 / S
R P - S
F P
3
4 O C
4 8 / S
R P - S
F P
4-57