Step 8: Configuring Snmp - Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration

Step 8: Configuring SNMP

Managing the SCE 2000 is possible also via a Network Management System (NMS) that supports
SNMP. By default, SNMP is disabled on the SCE 2000.
To enable SNMP management you must configure the following basic SNMP parameters:
•
•
To configure SNMP parameters, complete the following steps:
Step 1
Would you like to enter the SNMP configuration menu? [no]: y
Type y and press Enter.
The SNMP configuration dialog begins.
Step 2
Type y and press Enter.
Enable SNMP management? [no]: y
If you choose to disable SNMP management, skip the rest of this section and go to Step 9: Configuring the
Topology-Dependent Parameters. The rest of the dialog is not presented, as it is irrelevant when SNMP
management is disabled.
Step 3
The SNMP agent that resides inside the SCE 2000 will respond only to GET requests that use this
community string.
Enter SNMP GET community name:
Note that there is no default for this parameter.
Step 4
Type a number (1 through 99) or type "0" to permit access to all IP addresses, and press Enter.
Enter Access list number allowing access with this community string, use '0'
to allow all:
Step 5
Enter up to 20 SNMP GET communities as described in step 3 and step 4.
Would you like to add another SNMP GET community? [no]:
Step 6
OL-7824-02
SNMP traps status and managers.
Community strings (where an SNMP community string is a text string that acts like a
password to permit access to the SNMP agent on the SCE 2000).
Enter the SNMP configuration menu.
Enable SNMP management.
Type the SNMP GET community name and press Enter.
Assign an access list to restrict the SNMP management stations that may use this GET
community.
The maximum number of GET communities is 20.
To add more entries, type y and press Enter
•
Would you like to add another SNMP GET community? [no]:y
•
When all entries have been added, press Enter
•
Type the SNMP SET community name and press Enter.
SCE 2000 4xGBE Installation and Configuration Guide
Initial System Configuration
5-17