Preparing to Install the SCE 2000 Platform
Figure 4-1: SCE 2000 Measurements
Table 4-1
Dimension
Height
Width
Depth
Weight
Tools and Parts Required
The SCE 2000 chassis is fully assembled at the factory, including the application and software
packages. No assembly is required. However, you need the following tools and equipment to
install the SCE 2000 chassis and the rack-mount kit (if installing the SCE 2000 platform in a
rack), fan modules, and power supplies:
•
•
•
•
•
•
•
•
SCE 2000 4xGBE Installation and Configuration Guide
4-2
SCE 2000 Dimensions
Measurement
3.47 inches (9.5 cm)
17.4 inches (4.43 cm)
18 inches (4.6 cm)
33 lb (15 kg)
Number 1 and 2 Phillips screwdriver
1/4 inch flat-blade screwdriver
#¼" Hex Wrench
Screws compatible with your rack (for mounting the SCE 2000 to the rack)
12 AWG or 2.5-mm copper installation wire with hex or loop connectors for DC power leads
Ring terminals must be UL approved and suitable for 12 AWG wire.
Level (optional)
Tape measure (optional)
Appropriate cables to connect the SCE 2000 to the network and console terminal
Chapter 4
Installation and Maintenance
OL-7824-02