Initial System Configuration
Enter SCE 2000 priority:
1- primary
2- secondary
Enter your choice [1]:
Step 6
Enter On-failure behavior:
1- bypass
2- cutoff
Enter your choice [1]:
Step 7
Enter admin status of the SCE after abnormal boot:
1- Operational
2- Not-Operational
Enter your choice [1]:
The following examples present the procedure for configuring the topology-related parameters for
various topologies.
E
XAMPLE
Following is a sample topology configuration for a non-redundant topology using an optical
splitter, that is, a single SCE 2000 connected in receive-only connection mode, to one or two GBE
links
Would you like to enter the Topology configuration menu? [no]: y
Would you like to enter the Topology configuration menu? [no]: y
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]: 2
Is this a cascade deployment? [no]: no
Enter admin status of the SCE after abnormal boot:
1- Operational
2- Not-Operational
Enter your choice [1]: 1
Data collection for the system configuration is completed.
All other parameter values are automatically assigned by the system.
SCE 2000 4xGBE Installation and Configuration Guide
5-22
Chapter 5
Connecting the Management Interfaces and Performing Initial System Configuration
To specify Primary, press Enter.
•
•
To specify Secondary, type 2 and press Enter.
Specify the On-failure link behavior.
•
To specify Bypass, press Enter.
To specify Cutoff, type 2 and press Enter.
•
Specify the status of the SCE 2000 after abnormal boot.
To specify Operational status after abnormal boot, press Enter.
•
To specify Not-Operational status after abnormal boot, type 2 and press Enter.
•
#1:
OL-7824-02