Rebooting And Shutting Down The Sce Platform; Rebooting The Sce Platform - Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual

Chapter 7 Basic SCE 2000 Platform Operations

Rebooting and Shutting Down the SCE Platform

Rebooting the SCE Platform

Rebooting the SCE 2000 platform is required after installing a new firmware, in order for that
firmware to take effect. There might be other occasions where rebooting the SCE 2000 platform
is necessary.
When the SCE restarts, it loads the startup configuration, so all changes made in the running
Note
configuration will be lost. You are advised to save the running configuration before performing reload,
as described in Saving the Configuration Settings (on page 7-7).
To reboot your SCE 2000 platform, complete the following steps:
Step 1
A confirmation message appears.
Step 2
E
XAMPLE
The following example shows the commands for system reboot.
SCE 2000# reload
Are you sure? y
the system is about to reboot, this will end your CLI session
OL-7824-02
At the SCE 2000# prompt, type reload and press Enter.
Type Y to confirm the reboot request and press Enter.
:
Rebooting and Shutting Down the SCE Platform
SCE 2000 4xGBE Installation and Configuration Guide
7-11