Chapter 8
Troubleshooting
• GBE link is up (GBE
interface link LED is
continuous green and
GBE interface Tx
LED is flashing)
• Peer does not receive
traffic from SCE
2000
• GBE link is up (GBE
interface link LED is
continuous green)
• No traffic received
(GBE interface Rx
LED is not flashing)
OL-7824-02
CLI commands:
Auto-negotiation is disabled
at the SCE 2000 but enabled
• show interface
at peer.
GigabitEtherne
t 0/# counters
Check printout of this
command for: "Out
unicast packet". This
counter should be
constantly
incrementing.
show interface
GigabitEthernet
0/#
No traffic is being
transmitted to the SCE 2000
from its peers
Auto-negotiation is disabled
at the SCE 2000 but enabled
at peer
SCE 2000 4xGBE Installation and Configuration Guide
Problem Solving Using a Subsystems Approach
Check auto-negotiation
("Configuring the GBE
Interface
Parameters" on page
7) configuration in the SCE
2000 and in peer.
Check traffic connection at pee
Check auto-negotiation
("Configuring the GBE
Interface
Parameters" on page
7) configuration in the SCE
2000 and in peer.
6-
6-
8-15