Cabling The External Optical Bypass Module - Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual

Installing the External Bypass Module

Cabling the External Optical Bypass Module

The following procedure describes how to cable the External Optical Bypass module. Note the
following:
•
•
•
Figure A-4: Bypass Connectors on the Rear of the SCE 2000
SCE 2000 4xGBE Installation and Configuration Guide
A-6
All connections to the External Optical Bypass module are on the front panel of the module.
If installing only one module, the connections are as follows:
Connect the fiber (steps 3 and 4) to the GBE-1 Line ports on the SCE 2000 platform.
•
Connect the control cable to the Bypass 1 9-pin D-Type connector on the rear panel of the
•
SCE 2000 platform.
If installing two modules, repeat the entire procedure for the second module, with the
following changes:
Connect the fiber (steps 3 and 4) to the GBE-2 Line/Cascade ports on the SCE 2000
•
platform.
Connect the control cable to the Bypass 2 9-pin D-Type connector on the rear panel of the
•
SCE 2000 platform.
Appendix A The External Optical Bypass Module
OL-7824-02