Barbecook SPRING 2002 Manual page 26

If your country is not listed in the table, use the coupling
that meets the standards that apply in your country.
6.3.1 Coupling A
You require a 19 mm wrench and a Phillips screwdriver.
1. Screw the coupling onto the gas tube on the appliance (A)
and tighten it with a 19 mm wrench (B).
A
A
2. Slide the hose over the coupling (C) and tighten the
C
clamping ring with a Phillips screwdriver (D).
C
6.3.2 Coupling B
You require a 22 mm wrench and an adjustable wrench.
1. Screw the coupling onto the gas tube on the appliance (A)
and tighten it with a 22 mm wrench (B).
26
B
B
D
D
www.barbecook.com
A
A
2. Screw the gas hose onto the coupling (C) and secure it
C
with two wrenches. Hold the coupling firm with one 22 mm
wrench and tighten the hose with an adjustable wrench.
C
6.4. Connect the hose and gas bottle to the regulator.
You will require a Phillips screwdriver and/or an adjustable
wrench depending on the type of regulator that you are using.
1. Connect the hose to the pressure regulator. Proceed as
follows:
• If the hose is fitted with a clamping ring, slide the hose over
the regulator and tighten the clamping ring with a Phillip
screwdriver (A).
• If the hose is fitted with a nut, screw the hose onto the
regulator and tighten the nut with and adjustable wrench (B).
2. Connect the pressure regulator to the gas bottle. Proceed as
follows:
• If the regulator is fitted with a nut, screw the regulator
onto the gas bottle clockwise and tighten the nut with an
adjustable wrench (C).
• If the regulator has a thread, screw the regulator
onto the gas bottle counter-clockwise (D)
Only use regulators that satisfy EN 16129.
B
B
D
D