Endless Pools FASTLANE PRO Owner's Manual page 23

Hide thumbs Also See for FASTLANE PRO:

Table of Contents

After the liner is installed, add water to the pool to weigh the liner down pulling it tight. When the liner is

tight, cut the holes for each thru-wall fitting and threaded rod hole using a sharp utility knife. Cut the holes

as small as possible for the threaded rods (Fig 4.22).

Fig. 4.22

Using a scratch awl, poke the holes out in each star thru-wall fitting (holes located in 12, 3, 6, 9 clock

positions) and install the thru-wall faceplates using the screws provided. Tighten the screws with a hand

screwdriver to avoid cracking the faceplates. Apply RTV or a similar caulk to the threaded stud and rubber

washer and thread each stud into the 3/8" (9,5mm) holes in the liner/pool wall making sure the rubber

washer is flush against pool liner (Fig 4.23).

Fig. 4.23

Fastlane

Pro Swim Unit Installation

Table of Contents

Need help?

Do you have a question about the FASTLANE PRO and is the answer not in the manual?